SmartSkim® Magnom™ core above after recycling 2,500 gallons of coolant. These contaminants were removed AFTER a 5 micron filter. Bottom core shows magnetic core after cleaning.
|
- It’s important to note that this SmartSkim® Magnom™ was deployed on the clean, discharge side of a 5 micron filter. All the captured contaminants you see are below 5 micron.
- Top photo shows the Magnom™ after recycling 2,500 gallons of semi synthetic coolant. Small sub 5 micron sized particles have been removed from the coolant with no consumables and no damage to the coolant.
- Lower photo shows the Magnom™ core cleaned by 1 minute pressure wash.
- Coolants and other industrial fluids typically can not be filtered below 5 micron. Any filter rating tighter than that will separate out and remove the constituent parts of the source fluid. The Magnom™ is the only safe way to remove sub 5 micron contaminants without damaging your industrial fluids.
- The flow through the Magnom™ captures any ferric contaminants that get by previous filters. Unlike traditional pin type magnetic separators which allow wash off of captured contaminants, the Magnom™ does not release contaminants. There is no failure mode. No matter how full the cores become Magnom™ patented bypass technology guarantees full flow with no pressure drop.
|
